Berger 100HP Snowguards

Berger 100HP Snowguards in Copper (SGC100HP), or Stainless Steel (SGS100HP). Select below.

9 inches long overall, 4 inches wide, 1 Inch wide strap, shoe is 3 inches high, sits about 2.5 inches up off roof surface. These are good, economy snow guards for new roof installations (not a retrofit model).

Snow guards should be installed where the potential for the sudden sliding of ice and snow can be hazardous to people or property below. Falling snow is a life safety issue, and careful consideration of liability issues should be part of a carefully designed roof system in all areas prone to winter snow and ice.

Minimum purchase quantity: 6 units

berger_snowguard_guide.pdf 222.4 kB
GENERAL INSTALLATION GUIDELINES
Berger_100HP_Install.pdf 96.4 kB
BERGER 100HP INSTALLATION GUIDELINES
Berger_SG_Worksheet.pdf 178.3 kB
WE CAN HELP FIGURE OUT YOUR LAYOUT
Berger_100HP_CAD.pdf 45.3 kB
CAD DRAWING
Berger_Layout_WorkSheet.pdf 2.1 MB
BERGER LAYOUT WORKSHEET
Berger_Reference_Guide_2019.pdf 750.4 kB
BERGER REFERENCE GUIDE

NOTE: Returned Berger snowguards require a 25% restocking fee, so make sure you're getting the right ones!

IMPORTANT NOTE ABOUT SHIPPING RATES: We often can ship snowguards free when there is sufficient quantity! In any case, for an accurate shipping cost for snowguards, please call us at 814-786-9085 (M-F, 9-5, eastern time, USA), or send us an email and include the item, quantity, "ship to" zip code, and type of UPS shipping method such as UPS ground.

Manufacturer
Berger Snow Guards
Type of Roof
Synthetic Roof
Metal Type
Stainless Steel - SGS100HP, Copper - SGC100HP

There are no comments yet. Be the first to leave a comment