Berger 100 Retrofit
Berger 100 Retrofit Snow Guards.
14" maximum reach to nail. High quality, durable retrofit snow guards for installation on new or existing slate or asphalt shingle roofs.
SGS100: Stainless Steel - $8.20
SGC100: Copper - $13.25
NOTE: Returned Berger snow guards incur a 25% restocking fee. Please call with any questions to make sure you're ordering the correct product for your project.
We offer free shipping on orders of sufficient quantity. For more information, call us at 814-786-9085, or send us an email and include the item, quantity, and shipping zip code.
Snow guards should be installed where the potential for the sudden sliding of ice and snow can be hazardous to people or property below. Falling snow is a safety issue, and careful consideration of liability issues should be part of a carefully designed roof system in all areas prone to winter snow and ice.
The following recommendation is for a typical application, slate size 12 inches x 18 inches, with a 7 1/2 inch exposure, and a roof pitch of 12/12 (45 degrees). This is a typical example, and can be used and adjusted for differing conditions such as high snow loads, or drifting conditions. For this example, the rafter length is 18 feet.
Guards shall be installed in horizontal rows parallel to the eave. The first row shall be installed on the third course of slate, and spaced no more than 24 inches apart in the rows. Subsequent rows shall be spaced 30 inches vertically (4th slate course) and the guards offset 12 inches from the course below. Install 6 horizontal rows. The preceding technical information is for informational purposes only and is not intended to replace the manufacturer's recommendations for a particular project. We will provide layouts upon receipt of roof plan with elevations. Manufacturer is not responsible for improper installation, or installation in insufficient quantities.
Metal TypeSGG100 Galvanized, SGS100 Stainless, SGC100 Copper